![]() ![]() Thanks for the suggestion - but I don’t think so because if I disable the W it launches.Īt least with the old LinuxCNC, you had to define enoughĪxes (without skipping over any) to include the last axis > of task running? Maybe from a previous run of linuxcnc that wasn't shut > On Sep 8, 2015, at 7:15 PM, Sebastian Kuzminsky wrote: Of task running? Maybe from a previous run of linuxcnc that wasn't shut > I grepped around for ‘inihal’ but find no such term in my configs. > More information may be available when running from a terminal. > A configuration error is preventing LinuxCNC from starting. > HAL: ERROR: duplicate component name 'inihal' > Can not find -sec APPLICATIONS -var DELAY -num 1 > Anyhow, I can’t get Axis to launch with the W enabled. ![]() I didn’t set up the limit switches because I wasn’t sure what pins to use. > I defined the new axis as W and set it up the way the other axes are setup as far as I can tell. > I am trying to add a 4th axis to my USC from Pico Systems. Full error log is here:īTW: I assume the 5V pin on the stepper drive goes to the 5V on the USC, but where does the enable go (been a while!)? I grepped around for ‘inihal’ but find no such term in my configs. More information may be available when running from a terminal. HAL: ERROR: duplicate component name 'inihal'Ī configuration error is preventing LinuxCNC from starting. I get the error:Ĭan not find -sec APPLICATIONS -var DELAY -num 1 I didn’t set up the limit switches because I wasn’t sure what pins to use.Īnyhow, I can’t get Axis to launch with the W enabled. I defined the new axis as W and set it up the way the other axes are setup as far as I can tell. I am trying to add a 4th axis to my USC from Pico Systems. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |